MacHouse Software

 

   Last updated: March 29, 2011

 

 

 

 

 

Image2Go - User's Guide

 

Mac software Image2Go

 

 

5. Universal Locator

Universal Locator is a feature that will allow the user to comprehensively manage destination paths.  Previously, the user could save only one unique destination path per component.  And it was difficult to switch from one destination path to another under the same component.  You can now share the same destination paths stored in Universal Locator regardless of which Image2Go component you are currently using.

 

 

Mac software Image2Go

Screenshot 5-1

 

Mac software Image2Go

Screenshot 5-2

 

 

In order to use Universal Locator, first click on the toolbar button labeled Locator.  (See Screenshot 5-1.)  Then a small window will pop up to the right of the main widown.  (See Screenshot 5-2.)  Notice that each component now has a small add button.  This button will become accessible when any of the paths is selected in Univeral Locator's listbox.  If no destination path is selected, then the add button on the main window will be automatically put into disabled.

 

 

Mac software Image2Go

Screenshot 5-3

 

Mac software Image2Go

Screenshot 5-4

 

 

In order to add a new destination folder, simply grab a folder and drag and drop it directly onto the listbox.  (See Screenshot 5-3.)  Now, all you have to do is simply click on the add button in order to pass the selected destination to the path field right below the Else radio button.  (See Screenshot 5-4.)

As for Stamp, you don't have the Toolbar menu.  So, in order to open Universal Locator, choose Window > Show Universal Locator before clicking on the Export button to move on to the next step.  (See Screenshot 5-5.)  Then you can add new destination folders.  You can also select destination folders/volumes, one a time, with the select-folder window by clicking on the Select button, which is located at the bottom of the Universal Locator's window.

 

Mac software Image2Go

Screenshot 5-5

 

Mac software Image2Go

Screenshot 5-6

 

 

Before qutting the application or closing Universal Locator's window, click on the Save button to save changes.  And Image2Go will automatically load the entire set of your destination paths whenever you launch it and whenever you open Universal Locator.

 

 

Mac software Image2Go

Screenshot 4-23

 

Mac software Image2Go

Screenshot 4-24

 

 

In order to delete an existing destination path, first, select one in the list.  Then simply press the Delete key or Backspace key on the keyboard.  Again, in order to make changes permanent, don't forget to press the Save button.

 

 

<< Previous page   Next page >>